LED signboards that still look right at midnight.
A lit sign is only as good as its worst LED. We build them so a failed module can be replaced from the front, and we test the whole board at night before it leaves the workshop.
The three ways to light a letter
Reverse-lit (halo / backlit)
LEDs sit inside the letter facing the wall. The letter itself stays solid, ringed by a glow. The most premium-looking of the three, and the most sensitive to the wall — it needs a flat, pale surface about 25 mm behind the letter to bounce off. On a dark or rough wall, the halo disappears.
Front-lit
A diffused acrylic face set into a metal or aluminium return, lit from inside. This is the brightest from a distance, which is why highway, mall and petrol pump signage almost always uses it.
Edge-lit and neon flex
Silicone LED flex bent to follow a script or an outline, mounted on a cut acrylic backing. Popular for cafés, salons and interior feature walls. Dimmable, and available in fixed colours or RGB.
What we use inside
| Part | What we fit | Why |
|---|---|---|
| LED modules | Branded 12 V modules, IP65 for exterior | Cheap unbranded modules drift in colour — half the sign goes yellow while half stays white |
| Driver | Sized with headroom, mounted in a serviceable box | A driver run at its limit is the single most common failure in Indian signage |
| Colour temperature | 6500 K cool white as standard, 3000 K warm on request | Warm white suits brass, gold and hospitality; cool white suits steel and retail |
| Wiring | Concealed, single feed to a raceway where possible | One power point instead of a wall full of cable entries |
Acrylic letters
Acrylic is the cheapest way to get a clean, lit letter. Faces are 3 mm cast acrylic — cast, not extruded, because extruded sheet crazes at the router edge. Standard builds are a white or opal face for even light spread, or a coloured face matched to the brand.
Acrylic on its own is also used unlit for interior signage, where it is routed and pin-mounted like metal at a fraction of the cost.
Before you buy any lit sign, ask these
- Which brand of LED module and driver, in writing
- Whether the driver is inside the sign or in a separate serviceable box
- Whether modules can be replaced without removing the letter from the wall
- Whether the sign was night-tested before dispatch
- Who pays for a scaffold if one module fails in month three
A quote that is 20% cheaper and silent on all five will cost more within two years.
Common questions
How much electricity does an LED signboard use?
Very little. A typical nine-letter shop fascia in halo lighting draws roughly the same as one or two ceiling fans. Front-lit boards use more because they light a larger face area.
Backlit or front-lit — which should I choose?
Front-lit if the sign must be read from far away or from a moving vehicle. Backlit if the sign is on a clean pale wall at close range and you want it to look premium rather than loud.
Can the sign be switched on automatically at dusk?
Yes. We fit a timer or a photocell in the driver box so the sign follows daylight without anyone remembering to switch it.
What happens if one LED module stops working?
On a well-built sign, that module is replaced from the front in minutes. That is why we mount modules on removable strips and keep drivers in a serviceable box — a sealed sign means dismantling the whole letter.
Also from VAELUX
Get a costed estimate today
Send the sign width, the material you have in mind and a photograph of the wall. That is usually enough for us to quote.